Professionally restored Thorens TD~124 restoration included1) Visual and Operational inspection to determine any obvious problems 2) Complete disassembly, cleaning, and lubrication of all mechanical components 3) Replacement/repair of any worn parts 4) Complete rebuild of the E50 motor including new bushings, oil retention felts, thrust pad, silicon nitride armature ball, one week run-in and final adjustments under full operating load 5) New spindle bushings, thrust pad, gasket 6) Diamond polish spindle 7) New motor suspension grommets 8) Six new platter pads 9) Polish secondary platter 10) Three step 3M paint polishing 11) New Belt 12) Adjust eddy brake 13) Clean and true Idler Wheel, install new sintered bronze bushing and new teflon wear washer 14) Adjust clutch 15) New grounded power cord 16) Replace rubber mat 17) Final run-in and verification of all operations Includes Ortofon AS 309S tonearm Sorane Abis 10 inch arm New Thorens 124 Arm Board for a tonearm. I can offer an ABIS or SME 3009 or Ortofon 12 inch tonearm Installation of the above listed parts, complete motor service, clean and polish Thorens 124 under-chassis and aluminum outer platter is very straight and not warped Chassis Restoration and Service The chassis was completely disassembled and cleaned of all oil and grease. All parts, fixed and moving, are replaced as necessary, and the chassis is greased and oiled according to original factory specifications. The motor is installed and the entire drive mechanism precisely adjusted for optimum performance based on our unique access to the original manufacturing and servicing procedures. The turntable is tested, run in and checked under precise conditions for one entire week. prefer customer pick up....+/- 1 hr West of NYC where it can be inspected and touched and listened to.
| 
