Top-Notch Amplifier Technology! No Fan, No Noise!The Crown K1 Amplifier is the first amplifier to take advantage of Crown's new Balanced Current Amplifier technology. This technology yields extremely efficient power amplification, with the K1 producing much less heat - even while clipping - than typical amplifiers. Crown K1 Amplifier at a Glance: Balanced Current Amplifier technology ensures thermal stability without a fan!
Delivers 350 watts at 8 Ohms, up to 1500 watts (bridged) at 4 Ohms
Incredibly flat frequency response for compromise-free audio Massive power with one tenth the heat!
The K1 amp from Crown is the first amplifier to take advantage of Crown's new Balanced Current Amplifier technology. This technology yields extremely efficient power amplification while generating just one-tenth the heat of conventional amplifiers. In fact, the powerful K1 Amplifier can deliver an amazing 750 watts per channel into 2 Ohms (and that's a very solid 2 Ohms)! As a result the amp can put out clean, uncolored power without the use of a fan. No fan means the K1 runs quietly and cleanly, takes up less space in a rack and requires less maintenance. The K1 also boasts advanced circuitry protection that guards against DC, mismatched loads, internal faults and high frequency overloads. Crown is so confident of the K1's stability that it's backed by a three-year no fault warranty! Power to spare, no matter what your configuration
The Crown K1 Amplifier is rated to deliver 350 watts per channel at 8 Ohms, 550 watts into 4 Ohms or 750 watts per channel into 2 Ohms. In addition, in bridged mode the K1 has a capability of 1100 watts at 8 Ohms or 1500 watts at 4 Ohms - all while running without a fan! The K1 is cool, clean and quiet. Legendary Crown frequency response
Crown amps have a long history of providing crystal-clear audio response in critical listening situations, and the K1 Amplifier is no exception. Flat frequency response: (+/- .25 dB) from 20Hz to 20kHz ensure you get out of the K1 exactly what you put into it! Crown K1 Amplifier Features: Soft Start (Keeps amp from drawing large currents when first turned on)
Switchable Input Sensitivity (1.4V or 26dB)
Mono mode switches: Bridged, Y (parallel) or both (for daisy chaining)
Balanced XLR and 1/4" inputs
5-way binding posts
Channel 1 and Channel 2 gain controls with notched settings
LEDS: Thermal (Warns of need to dissipate heat), Clip (Warns of distortion in the amp), IOC (Input / Output Comparator: Warns of distortion at 1/30th the level of clipping by comparing the actual waveforms of the input to the output), Signal (glows when output signal is present), Enable (Indicates Power status)
Frequency Response: +/- .25 dB for 20Hz - 20kHz
Power Output (per Channel): 750 watts into 2 Ohms, 550 watts into 4 Ohms, 350 watts into 8 Ohms
Bridged (mono) power: 1500 watts at 4 Ohms, 1100 watts at 8 Ohms
Signal-to Noise (A Weighted): >100dB below rated power
Damping Factor: >3000 from 10 to 400Hz
Input Impedance: Nominally 20KOhms balanced, 10KOhms unbalanced
Passive convection cooling allows amplifier to drive 2 Ohm load at 8db into clip in 104 degree environment!
Power Supply can configure to 100, 120, 200, 220, 230, 240, 250 VAC at 50 or 60 Hz The Crown K1 Amplifier gives you power, response and reliability like no other amp!
| 
